Factory produced high quality tip rubber chair leg

This rubber chair leg tip puts rubber between the leg and floor. Custom dimensions and colors allow it to suit the furniture profile. Several compound choices are available, with hardness options ranging from 30 to 90 Shore A.

Inspect the bare chair leg before installing a replacement. A rough tube end or damaged edge can bear into the inside bottom of the tip. Even a correctly sized cover can wear prematurely if that concentrated contact remains. Fit the leg fully into its intended seating position, with the floor-contact base beneath it rather than folded to one side.

After installation, set the chair down normally on its intended floor and check that all legs make balanced contact without rocking. Examine the tips periodically for a thinning center or exposed leg end. Avoid dragging the chair across trapped grit, which can damage the floor even when the rubber itself is still intact.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Assess the grade against this fit requirement: Fit the leg fully into its intended seating position, with the floor-contact base beneath it rather than folded to one side.

Custom profile & fit

Custom dimensions and colors allow it to suit the furniture profile.

Assembly considerations

Inspect the bare chair leg before installing a replacement.

Design check

After installation, set the chair down normally on its intended floor and check that all legs make balanced contact without rocking.

Photos illustrate structure or material only. The chair tip needs a fully supported sole beneath the leg and an internal seat matched to the leg end. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.