Cheap custom molded rubber feet for chair legs

Rubber feet for chair legs provide custom contact layers at the bottom of the furniture. The internal shape needs to match the leg where it seats, while the base follows the chair's normal angle to the floor. An outside shape that looks similar may conceal a different socket depth or taper.

Check the complete set of supports before replacing a foot. The installed heights should remain consistent so the chair does not rock. Clean the leg ends and remove burrs or sharp material that could cut the rubber from inside.

Seat each foot fully and inspect the chair on a level surface. The caps should remain located when the chair is lifted or moved. Keep grit out of the contact faces during cleaning and inspect for thinning near the hard leg end. Replace damaged feet before that end reaches the floor. The correct profile and selected compound should guide replacement rather than price or appearance alone, preserving the intended support and retention of the original arrangement.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Assess the grade against this fit requirement: The internal shape needs to match the leg where it seats, while the base follows the chair's normal angle to the floor.

Custom profile & fit

An outside shape that looks similar may conceal a different socket depth or taper.

Assembly considerations

Seat each foot fully and inspect the chair on a level surface.

Design check

Keep grit out of the contact faces during cleaning and inspect for thinning near the hard leg end.

Photos illustrate structure or material only. An outside shape that looks similar may conceal a different socket depth or taper. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.