Crutch Rubber Tips/ Wear-resistant Floor Protector

Crutch rubber tips cover the lower end of the compatible support and place rubber against the floor. This entry is described as a wear-resistant floor protector, with custom material, size and color options. The term describes its purpose but does not supply a quantified wear life or device rating.

Wear needs to be checked at more than the outer edge. The support end can press into the inner base, and hard particles may become embedded underneath. Either condition can reduce the intended separation even while the sidewall looks intact. Use the correct replacement configuration for the device rather than selecting by a similar outside shape.

Check that the tip reaches its designed seat and cannot move independently of the support. Keep the contact surface clean and examine it before continued use. A punctured center or split rim calls for replacement, not an additional layer placed over the damaged tip. When fitting a new part, inspect the underlying support end so a sharp or damaged surface does not repeat the same wear pattern.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Compare firmness under load at the intended contact face. Either condition can reduce the intended separation even while the sidewall looks intact.

Custom profile & fit

Check that the tip reaches its designed seat and cannot move independently of the support.

Assembly considerations

When fitting a new part, inspect the underlying support end so a sharp or damaged surface does not repeat the same wear pattern.

Design check

Wear needs to be checked at more than the outer edge.

Photos illustrate structure or material only. The support end can press into the inner base, and hard particles may become embedded underneath. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.