Floor protector chair leg caps durable rubber feet

Slip-on rubber feet formed as chair leg caps fit over hard leg ends with a custom molded covering. The internal profile should fit the leg, while the base provides the intended contact with the floor. A correct cap helps keep the hard support covered, but the condition of the contact surface matters during use.

Measure the leg at its seating depth and check any taper or angle. The caps should support the chair evenly without changing its stance. Clean the leg ends and remove sharp material before installation so the rubber is not damaged from inside.

Inspect the bottoms during routine cleaning and remove trapped grit. Particles pressed into the rubber can mark a floor even when the cap itself remains intact. Check that the caps stay located when the chair is lifted or repositioned. Wear depends on the surface and handling conditions rather than a general durability description. Replace split or thinned caps before the leg end becomes exposed, using the matching height and profile so the chair remains level.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Compare firmness under load at the intended contact face. The internal profile should fit the leg, while the base provides the intended contact with the floor.

Custom profile & fit

Measure the leg at its seating depth and check any taper or angle.

Assembly considerations

Check that the caps stay located when the chair is lifted or repositioned.

Design check

Inspect the bottoms during routine cleaning and remove trapped grit.

Photos illustrate structure or material only. The internal profile should fit the leg, while the base provides the intended contact with the floor. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.