Factory custom made molded rubber tips foot chair

Custom molded rubber tips provide a contact piece at the end of a chair leg. Their shape should coordinate the internal attachment with the external floor contact area. Both determine the installed position, so the visible bottom face alone is not enough information to choose a replacement.

Review the leg profile and the direction in which it meets the floor. An angled leg may need a contact arrangement that differs from a vertical one. The rubber tip should seat fully and meet the surface on its intended working area rather than a narrow edge. Assess the whole chair for stable contact after fitting the complete set.

Material, size, and color can be customized around the product. During care, clean the lower face and inspect for uneven wear or splitting near the leg end. If the tip has been partly worn through, examine the underlying leg for damage before fitting another. The correct replacement should restore the intended contact geometry without relying on extra material at one corner.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Compare firmness under load at the intended contact face. Their shape should coordinate the internal attachment with the external floor contact area.

Custom profile & fit

Review the leg profile and the direction in which it meets the floor.

Assembly considerations

Both determine the installed position, so the visible bottom face alone is not enough information to choose a replacement.

Design check

Assess the whole chair for stable contact after fitting the complete set.

Photos illustrate structure or material only. An angled leg may need a contact arrangement that differs from a vertical one. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.