Chair leg feet cover rubber feet for metal chairs

Rubber feet for metal chair legs should be matched to the finished leg surfaces. Paint, a coating edge or a weld near the lower end can change the section that enters the cover.

Check the portion covered by the foot along its full depth. A local ridge can hold one side away or stop insertion while the mouth still appears tight. Correct an unintended sharp or damaged feature using the chair's appropriate maintenance method; do not use the rubber to mask it.

Select the custom cavity for the final section, including its intended finish. The compound should suit that contact and the substances used to clean the chair. Avoid introducing a lubricant or filler solely to force a mismatched foot onto the leg, since it can alter retention and the condition of the finish.

Inspect beneath a removed foot for trapped residue or coating damage. Before replacement, establish why the previous part split or loosened at that location. Restore the specified profile and seating depth so the new rubber meets the prepared leg rather than an unresolved surface defect.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Compare firmness under load at the intended contact face. Select the custom cavity for the final section, including its intended finish.

Custom profile & fit

Restore the specified profile and seating depth so the new rubber meets the prepared leg rather than an unresolved surface defect.

Assembly considerations

Before replacement, establish why the previous part split or loosened at that location.

Design check

Inspect beneath a removed foot for trapped residue or coating damage.

Photos illustrate structure or material only. Paint, a coating edge or a weld near the lower end can change the section that enters the cover. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.