Rubber cap for chair leg, Custom rubber feet tips

A rubber cap for chair leg use needs enough internal depth to reach its intended seat. The custom profile should follow the leg end, including any taper or change in section. The base then provides the contact beneath the chair at the required installed height.

Check whether the leg stops against the cap as designed or meets an unintended obstruction. A tip can look fitted from outside while leaving the load concentrated at an internal edge. The mouth should retain around the correct portion of the leg without excessive stretch.

Fit compatible components to the relevant legs and assess the chair on its normal surface. Select the compound for that surface and its cleaning conditions. During care, remove grit from the contact faces and inspect for rocking, movement, or splits. Replace with the matching internal profile and base thickness rather than choosing only by the exposed diameter. This preserves the chair's intended support without packing or modifying the leg connection.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Assess the grade against this fit requirement: A tip can look fitted from outside while leaving the load concentrated at an internal edge.

Custom profile & fit

Customize the internal mating profile and base thickness independently of the exposed outside diameter.

Assembly considerations

Fit compatible components to the relevant legs and assess the chair on its normal surface.

Design check

Check whether the leg stops against the cap as designed or meets an unintended obstruction.

Photos illustrate structure or material only. A tip can look fitted from outside while leaving the load concentrated at an internal edge. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.