rubber tips for chairs custom made silicone foot bumper

Rubber tips for chairs provide a molded contact layer at the leg ends. The custom socket should fit the receiving leg, while the base suits the chair's normal stance and installed support height. The rubber acts as a replaceable interface between the hard leg and the floor.

Check the leg profile and insertion depth before fitting. A tapered or angled leg may need a different socket or base from a straight tube. Compare all tips together so the chair rests evenly rather than rocking on mismatched heights.

Clean the leg ends and remove sharp material that could cut the rubber internally. Seat the tips fully and inspect the floor contact on a level surface. During care, remove grit from the bases and check for wear where the leg bears on the rubber. The tip should remain in place when the chair is lifted or moved. Replace damaged parts before the underlying leg becomes exposed, preserving the full profile rather than choosing only a similar outer shape.

Material options

Custom silicone or rubber formulation, with dimensions and color adapted to the mating component.

Hardness range

Silicone: 20–80 Shore A; rubber: 30–90 Shore A. Compare firmness under load at the intended contact face. The custom socket should fit the receiving leg, while the base suits the chair's normal stance and installed support height.

Custom profile & fit

Check the leg profile and insertion depth before fitting.

Assembly considerations

Seat the tips fully and inspect the floor contact on a level surface.

Design check

Compare all tips together so the chair rests evenly rather than rocking on mismatched heights.

Photos illustrate structure or material only. The custom socket should fit the receiving leg, while the base suits the chair's normal stance and installed support height. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.