Hot sale rubber tip protectors rubber feet for chair legs

Rubber tip protectors cover chair leg ends and provide a replaceable contact surface at the floor. A custom fit can follow the leg shape and the depth available for the cap. When an existing tip wears through or becomes loose, the replacement needs to restore the intended support height as well as cover the exposed end.

Compare the remaining feet before replacing only one. Differences in height or base shape can make the chair rock, even when the new protector fits its leg correctly. Check the leg ends for burrs or damage that could shorten the life of the replacement from inside.

Seat each tip fully and place the chair on a level surface to inspect the contact points. The caps should remain located when the chair is lifted and repositioned. Clean the bases periodically, removing grit before it becomes pressed into the rubber. Floor grip varies with the surface and contamination, so maintain the contact areas and avoid assuming that any rubber tip will prevent all sliding during use.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Compare firmness under load at the intended contact face. Differences in height or base shape can make the chair rock, even when the new protector fits its leg correctly.

Custom profile & fit

A custom fit can follow the leg shape and the depth available for the cap.

Assembly considerations

Seat each tip fully and place the chair on a level surface to inspect the contact points.

Design check

Check the leg ends for burrs or damage that could shorten the life of the replacement from inside.

Photos illustrate structure or material only. Differences in height or base shape can make the chair rock, even when the new protector fits its leg correctly. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.