Rubber End Tip/Replacement Silicone Rubber Tip Cap

Replacement rubber end caps can be customized in dimensions, material, color and logo to suit a particular support. For replacement, measure the support it fits; old rubber may have stretched or compressed during service.

Measure the support's end and available engagement length, including any taper or shoulder controlling the seated position. A replacement should reach that position without an edge folding into the cavity. Examine the underlying member for damage that may have caused the old tip to fail.

After fitting, carefully check the contact face and rim rather than judging attachment by appearance alone. A tip can feel tight near the opening but remain perched above its intended seat. Keep its base free from hard debris, and inspect the inside if the tip is removed during maintenance. Wear concentrated at the center can indicate pressure from the end beneath it, so that area deserves attention even when the sidewall appears sound.

Material options

Custom silicone or rubber formulation, with dimensions and color adapted to the mating component.

Hardness range

Silicone: 20–80 Shore A; rubber: 30–90 Shore A. Assess the grade against this fit requirement: Wear concentrated at the center can indicate pressure from the end beneath it, so that area deserves attention even when the sidewall appears sound.

Custom profile & fit

Measure the support's end and available engagement length, including any taper or shoulder controlling the seated position.

Assembly considerations

After fitting, carefully check the contact face and rim rather than judging attachment by appearance alone.

Design check

Keep its base free from hard debris, and inspect the inside if the tip is removed during maintenance.

Photos illustrate structure or material only. A tip can feel tight near the opening but remain perched above its intended seat. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.