Rubber feet synthetic rubber protective sleeve cover for table/chair/tube

A rubber protective sleeve cover encloses a tube or furniture-leg end, replacing exposed hard contact with a molded rubber surface. The appropriate sleeve depth depends on the receiving part. A straight table tube may accept a long cover, while a chair leg with a nearby bend or brace may leave only a short fitting area.

Measure the available straight section as well as the end profile. The sleeve should reach its intended seat before meeting an obstruction. If the tube is open, the cut edge must be smooth enough that it does not slice the rubber from within when the furniture is loaded or moved.

Evaluate the fitted cover in the item's normal resting position. The base should meet the surface without rolling onto an unsupported sidewall. Custom material selection should reflect the floor finish and expected cleaning exposure. Inspect the rim and underside when moving the furniture, and replace sleeves that creep off the end rather than relying on extra stretching to hold an unsuitable fit.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Assess the grade against this fit requirement: A straight table tube may accept a long cover, while a chair leg with a nearby bend or brace may leave only a short fitting area.

Custom profile & fit

Measure the available straight section as well as the end profile.

Assembly considerations

Evaluate the fitted cover in the item's normal resting position.

Design check

Custom material selection should reflect the floor finish and expected cleaning exposure.

Photos illustrate structure or material only. If the tube is open, the cut edge must be smooth enough that it does not slice the rubber from within when the furniture is loaded or moved. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.