Custom made rubber suction cup feet with screw

Screw-on rubber feet with suction cup bases should be developed around the device base and supporting surface. For an order of screw-on feet, specify the receiving screw connection and installed support height. The fixing holds each foot to the product, while its cup face meets the surface below it. Tightening should not twist the rim or change the intended foot height unpredictably.

Material, dimensions, hardness and color can match the application. Define thread engagement and clearance inside the base so the fastener does not interfere with internal parts. Check the available contact area beneath the device before choosing the cup profile.

Evaluate the complete set after fastening. Each foot should meet the surface evenly without leaving the device rocking or concentrating load at one point. Assess retention under representative use and keep the contact faces clean before placement. During maintenance, inspect both the screw connection and cup rim. A loose foot attachment differs from loss of suction at the surface, so identify the affected interface before replacing the part. Preserve the intended height and configuration across the set.

Material options

Rubber compound options, customized alongside the profile and contact conditions.

Hardness selection

Solid rubber options: 30–90 Shore A. Define thread engagement and clearance inside the base so the fastener does not interfere with internal parts.

Custom geometry

Material, dimensions, hardness and color can match the application.

Fit evaluation

Check the available contact area beneath the device before choosing the cup profile.

Color & OEM

Custom colors; OEM markings outside the suction contact face.

Photos illustrate structure or material appearance only. Tightening should not twist the rim or change the intended foot height unpredictably. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.