Hot sale silicone waterproof mechanical keypad

A waterproof mechanical keypad requires a control surface that moves freely within an enclosure designed for its intended exposure. Holding the silicone perimeter securely should not leave the keys partly loaded before use. The available clearance around the moving sections is as important as the way the outer edge is retained.

Trial the keypad before and after the housing is fastened. Compare key travel and return, paying attention to controls near the edges. If a key begins rubbing only after closure, check the retaining surfaces and alignment instead of assuming the rubber needs to be softer.

ETOL offers custom geometry, color, hardness and legends. Any required resistance to water must be assessed at the finished interface under specified conditions. A product description alone does not establish that the surrounding electronics can be washed or immersed.

During installation, keep the perimeter flat and avoid pulling the key tops to adjust its position. Inspect the underside for trapped particles and confirm operation after the complete fastening sequence. For later cleaning, follow the device's intended procedure and check the rubber for cuts before reassembly. A damaged edge should not be compensated for by simply tightening the enclosure further.

Material options

Silicone. Custom formulation and color for the intended contact conditions.

Hardness selection

Silicone: 20–80 Shore A. Compare key travel and return, paying attention to controls near the edges.

Custom dimensions

The available clearance around the moving sections is as important as the way the outer edge is retained.

Fit & assembly

If a key begins rubbing only after closure, check the retaining surfaces and alignment instead of assuming the rubber needs to be softer.

Use & inspection

For later cleaning, follow the device's intended procedure and check the rubber for cuts before reassembly.

Photos illustrate structure or material only. A waterproof mechanical keypad requires a control surface that moves freely within an enclosure designed for its intended exposure. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.