Custom molded silicone rubber feet for shelves and chair

These silicone rubber feet are custom molded for compatible shelf or chair supports. The receiving cavity and base dimensions should preserve the furniture's intended contact height, with color and compound options available. Consistent seating matters when several feet work together beneath one item.

Check the end of each support before fitting. A coating build-up, rough seam or taper can stop one foot earlier than the others. The rubber should reach its designed seat without a folded wall or concentrated cut from the member underneath.

Set the furniture on its intended surface and compare contact across the supports. A mismatch should be traced to the leg, seating position or foot profile rather than corrected by leaving one cap partly fitted. Keep the floor-contact faces clean during assembly and packing. During later maintenance, inspect the center of each base for wear from the support end. Replacing a foot should restore the original seated height and compound, not merely cover the exposed member with any available cap that appears close in size.

Material options

Custom silicone compound; formulation and geometry developed together.

Hardness selection

Silicone options: 20–80 Shore A. Check the end of each support before fitting.

Custom geometry

The receiving cavity and base dimensions should preserve the furniture's intended contact height, with color and compound options available.

Fit evaluation

Consistent seating matters when several feet work together beneath one item.

Color & OEM

Custom colors; OEM markings clear of the working interface.

Photos illustrate structure or material appearance only. The rubber should reach its designed seat without a folded wall or concentrated cut from the member underneath. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.