Silicone rubber foot tips rubber feet for chair

Silicone rubber foot tips fit the intended chair attachment to provide a rubber contact at the lower end. The outer face shows wear against the floor, but the hidden fitting section also needs attention. Movement between the chair and the tip can damage that section before the visible base wears through.

Custom dimensions, material and hardness allow the foot to follow the chair design. Compare the mating end with the internal fit and check for sharp features, loose hardware or an irregular surface that could cut or distort the rubber. The required contact height should be maintained across the chair.

Seat the tips fully and inspect the chair on the intended surface. When replacing a loose part, examine its inside and the attachment area rather than simply selecting a tighter size. Clean away debris before fitting the replacement. During ordinary care, inspect both the floor contact and any visible movement at the retained edge so changes in fit are addressed before the underlying chair part reaches the floor.

Material options

Custom silicone or rubber formulation, with dimensions and color adapted to the mating component.

Hardness range

Silicone: 20–80 Shore A; rubber: 30–90 Shore A. Assess the grade against this fit requirement: Compare the mating end with the internal fit and check for sharp features, loose hardware or an irregular surface that could cut or distort the rubber.

Custom profile & fit

Custom dimensions, material and hardness allow the foot to follow the chair design.

Assembly considerations

Seat the tips fully and inspect the chair on the intended surface.

Design check

When replacing a loose part, examine its inside and the attachment area rather than simply selecting a tighter size.

Photos illustrate structure or material only. The outer face shows wear against the floor, but the hidden fitting section also needs attention. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.