Chair Leg Tips Caps Anti-slip 2″ Rubber Tips

Chair leg tips cover the lower ends of chair legs to form a flexible interface with the floor. This listing refers to a nominal two-inch size, but a usable fit also depends on the socket shape, depth and base angle. Compare those features with the finished leg rather than selecting by the visible size reference alone.

For a round leg, measure the diameter where the cover engages. For another section, include the widths and corners that the rubber must accommodate. A chair with angled legs also needs attention at the base: the cap should contact the floor in its intended way instead of resting only on one thin edge.

ETOL can customize material, hardness, dimensions and colors. Consider the furniture's normal movement when choosing the profile. A cover that stretches tightly over the leg may still be displaced if its outer rim catches while the chair is moved.

Clean the leg ends and support the chair before fitting. Seat each cap fully, then place the chair on a clean, level surface and inspect all contact points. If one cover does not sit squarely, review the leg shape and insertion depth rather than trimming the rubber at random. During routine care, remove grit from the feet and replace damaged pieces before a bare leg can contact the floor.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Assess the grade against this fit requirement: A cover that stretches tightly over the leg may still be displaced if its outer rim catches while the chair is moved.

Custom profile & fit

Compare those features with the finished leg rather than selecting by the visible size reference alone.

Assembly considerations

Seat each cap fully, then place the chair on a clean, level surface and inspect all contact points.

Design check

If one cover does not sit squarely, review the leg shape and insertion depth rather than trimming the rubber at random.

Photos illustrate structure or material only. For another section, include the widths and corners that the rubber must accommodate. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.