Good quality rubber feet for chair leg protectors

Rubber feet used as chair leg protectors provide a custom interface between the chair structure and the floor. Their retention should suit ordinary handling, including lifting and repositioning the chair. The inner fit must keep the protective part on the leg while the lower surface remains correctly aligned for use.

Check the leg profile and seating depth before selecting the foot. A loose cap can remain in place while the chair stands still yet move when it is lifted. The installed contact face should meet the floor evenly across the complete support set. Material and size need to suit that arrangement and the actual surface conditions.

During cleaning, remove grit from beneath the feet and inspect the openings for tears. If a protector is missing after movement, inspect the leg before fitting another, since damage or a mismatch may explain the loss. Use the specified replacement geometry rather than a similar cap that alters the chair's height or contact angle at one position.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Assess the grade against this fit requirement: Their retention should suit ordinary handling, including lifting and repositioning the chair.

Custom profile & fit

Check the leg profile and seating depth before selecting the foot.

Assembly considerations

The inner fit must keep the protective part on the leg while the lower surface remains correctly aligned for use.

Design check

During cleaning, remove grit from beneath the feet and inspect the openings for tears.

Photos illustrate structure or material only. The installed contact face should meet the floor evenly across the complete support set. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.