25mm rubber tips 50mm 20mm chair leg tips

These chair leg tips cover furniture-leg ends with a flexible rubber interface. The 25 mm, 50 mm and 20 mm size references accompany customizable profiles for different furniture-leg configurations. Those references should be related to the actual socket and leg geometry before a replacement set is chosen.

Check all the legs, especially on a chair with a tapered frame or different front and rear sections. Similar visible widths may hide different end angles or insertion depths. Compare the finished leg dimensions with the inside of the tip rather than using the worn outside footprint of an old cover as the only guide.

Material, hardness, color and molded identification are available for custom designs. Keep the seating depth consistent with the intended furniture configuration so the covers do not introduce rocking. A thicker rubber base on one leg should not become an improvised correction for a damaged frame.

During installation, support the chair, remove old debris and fit each tip fully. Lower it onto a clean, level area and check the contact faces. If one cover rolls at its edge, inspect the leg angle and socket fit before moving on. After the chair has been repositioned, verify that every cover remains on its leg and that no grit has become trapped beneath a foot.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Compare firmness under load at the intended contact face. Check all the legs, especially on a chair with a tapered frame or different front and rear sections.

Custom profile & fit

Compare the finished leg dimensions with the inside of the tip rather than using the worn outside footprint of an old cover as the only guide.

Assembly considerations

Support the chair, remove old debris and fit each tip fully.

Design check

Lower it onto a clean, level area and check the contact faces.

Photos illustrate structure or material only. The 25 mm, 50 mm and 20 mm size references accompany customizable profiles for different furniture-leg configurations. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.