Rubber chair leg tips/rubber protective feet

Rubber chair leg tips cover the contact end of a chair leg, but their wear pattern depends on how that leg meets the floor. An angled leg can press more heavily against one side of the tip. A suitable internal profile and base shape should accommodate the chair's geometry instead of forcing the cover to lean under load.

Look at the old tip before choosing a replacement. A thin patch on one side can reveal concentrated contact, while damage around the opening may indicate a poor grip or repeated movement. Simply choosing a thicker version can leave the underlying alignment problem unchanged.

Fit the replacement fully and compare its contact with the other legs. Check that the chair rests steadily without a rubber sidewall folded beneath the base. Keep grit from collecting under the contact faces, especially on floors where chairs are moved frequently. Reinspect newly fitted tips after use; a repeating wear mark in the same location is a reason to reassess the shape and seated position.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Assess the grade against this fit requirement: Check that the chair rests steadily without a rubber sidewall folded beneath the base.

Custom profile & fit

A suitable internal profile and base shape should accommodate the chair's geometry instead of forcing the cover to lean under load.

Assembly considerations

Reinspect newly fitted tips after use; a repeating wear mark in the same location is a reason to reassess the shape and seated position.

Design check

Fit the replacement fully and compare its contact with the other legs.

Photos illustrate structure or material only. A suitable internal profile and base shape should accommodate the chair's geometry instead of forcing the cover to lean under load. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.