Custom made chair and table legs rubber stopper

A rubber stopper fitted to a chair or table leg needs to fit the specific leg profile while maintaining the furniture's intended resting height. The part may be securely attached to one leg yet still cause rocking if it seats at a different depth from the remaining supports.

Measure the mating section and check corner radii or internal features as applicable. Remove burrs from a cut leg end before fitting, and make sure the stopper can reach its designed position without an obstruction. The outer contact face should suit the leg angle and the supporting surface.

Fit and assess the complete set on the assembled furniture. Check for uneven contact, exposed hard edges, and any movement of the stopper during ordinary relocation. The rubber component does not establish the load capacity of the chair or table. During care, remove grit from the contact faces and inspect wear across all positions. Replace with a compatible height and profile rather than assuming that any closure fitting the same nominal leg width will preserve stable support.

Material options

Rubber compound options, customized alongside the profile and contact conditions.

Hardness selection

Solid rubber options: 30–90 Shore A. Check for uneven contact, exposed hard edges, and any movement of the stopper during ordinary relocation.

Custom geometry

Measure the mating section and check corner radii or internal features as applicable.

Fit evaluation

Fit and assess the complete set on the assembled furniture.

Color & OEM

Custom colors; OEM identification positioned outside closure contact surfaces.

Photos illustrate structure or material appearance only. The part may be securely attached to one leg yet still cause rocking if it seats at a different depth from the remaining supports. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.