Custom made silicone rubber corner protector

A rubber corner protector can be custom molded around the point where two or more surfaces meet. Its internal angle, coverage length, and outer shape need to follow the actual corner. Material, hardness, dimensions, and color can be selected for the intended protective role.

Check the corner radius and any trim or seam near it. A protector may contact one face while remaining lifted from another if the internal profile differs. Its attachment arrangement should keep it located without interfering with nearby openings, moving parts, or required access.

Fit the component through the designed method and inspect each covered face rather than viewing only the outside point. The complete application determines the protection needed; a soft cover does not establish a particular impact rating. During care, remove debris from exposed edges and check for lifting, cuts, or permanent deformation. Replace with the matching internal geometry so that the original corner coverage is maintained instead of forcing a generic angle onto a different surface profile.

Material options

Silicone. Custom formulation and color for the intended contact conditions.

Hardness selection

Silicone: 20–80 Shore A. The complete application determines the protection needed; a soft cover does not establish a particular impact rating.

Custom dimensions

A protector may contact one face while remaining lifted from another if the internal profile differs.

Fit & assembly

Fit the component through the designed method and inspect each covered face rather than viewing only the outside point.

Use & inspection

Replace with the matching internal geometry so that the original corner coverage is maintained instead of forcing a generic angle onto a different surface profile.

Photos illustrate structure or material only. A rubber corner protector can be custom molded around the point where two or more surfaces meet. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.