Custom Mold Making Durable Rubber feet

Durable rubber feet begin with a molded profile that suits the contact and mounting conditions of the product. When a new mold is required, the drawing should identify more than the overall outline. The surfaces that locate the foot, carry the load or remain visible need clear requirements so that tooling and sample inspection focus on the features that matter in use.

Mark the floor-facing or bench-facing area and the mounting interface on the design. Identify dimensions that control the installed height and any edge that could be caught during handling. Discuss where a molding parting line is acceptable and whether a visible surface has a specific finish requirement. These details help avoid placing an unnecessary appearance demand on a hidden face while leaving a functional contact edge poorly defined.

ETOL offers custom mold development with material, hardness, color and dimensional options. Provide the expected contact conditions and the way the product is moved during service. If durability is a purchasing requirement, define the representative wear or handling evaluation rather than using the word as an unspecified service-life promise. A sample should demonstrate the intended fit and contact behavior before the design is treated as a production reference.

Inspect durable rubber feet both as molded parts and after fitting them to the mating assembly. Check the critical edges for unwanted flash, confirm the seating position and examine the base after the agreed trial. Keep the approved drawing and sample revision together so later mold or material changes receive the same review. In service, monitor wear at the actual bearing face and retention feature rather than judging condition only from the sidewall. For a tooling inquiry, submit the part model, mating component and clearly marked functional surfaces to make the design review specific and productive.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Assess the grade against this fit requirement: Check the critical edges for unwanted flash, confirm the seating position and examine the base after the agreed trial.

Custom profile & fit

Identify dimensions that control the installed height and any edge that could be caught during handling.

Assembly considerations

Inspect durable rubber feet both as molded parts and after fitting them to the mating assembly.

Design check

Keep the approved drawing and sample revision together so later mold or material changes receive the same review.

Photos illustrate structure or material only. Provide the expected contact conditions and the way the product is moved during service. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.