High quality custom adhesive rubber bumper feet

Adhesive rubber bumper feet provide a removable product component, but replacing one requires attention to the old bonding layer. Residue left beneath the new foot can change its height or create an uneven seat. This is particularly noticeable on rigid equipment that needs several feet to share support consistently.

Choose a replacement with the intended footprint, profile, and adhesive system. Assess the underlying surface after removing the worn foot, including any damage to a coating. Clean it by a method appropriate to that finish and allow it to reach the condition required for bonding before applying the new part.

Locate the foot accurately rather than stacking it over remaining rubber or tape. Check the full set of supports once the adhesive is ready for use, looking for rocking or unintended housing contact. If the old part failed by peeling at an edge, examine handling and placement as well as the bond. A replacement fitted in the same exposed position may face the same snagging force unless the arrangement is improved.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Compare firmness under load at the intended contact face. Choose a replacement with the intended footprint, profile, and adhesive system.

Custom profile & fit

Check the full set of supports once the adhesive is ready for use, looking for rocking or unintended housing contact.

Assembly considerations

A replacement fitted in the same exposed position may face the same snagging force unless the arrangement is improved.

Design check

Assess the underlying surface after removing the worn foot, including any damage to a coating.

Photos illustrate structure or material only. A consistent bonding layer and fitted footprint help the bumper feet share the support of a rigid housing. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.