High quality molded silicone buttons and keypads for remote

Keypads for remote controls need to work within the limits of a handheld enclosure. Users may hold the product in one hand and reach several controls with the thumb, so the spacing and height of molded silicone buttons should be considered alongside the width and shape of the housing.

Place frequently used controls where the intended hold gives comfortable access. Buttons near the perimeter need particular attention because a raised housing edge can obstruct an angled thumb press. At the same time, the panel openings must leave enough clearance for movement without exposing excessive gaps around the keys. Internal support and contact location should follow the chosen layout rather than being treated as an afterthought.

Try representative command sequences while holding the assembled remote. Press from different angles and check whether the product shifts in the hand or an adjacent button moves unintentionally. When cleaning, concentrate on residue around the key boundaries without pushing liquid into the enclosure. If a key returns slowly, inspect for contamination or interference; repeatedly pressing harder can conceal the underlying problem while placing additional strain on the flexible section.

Material options

Silicone. Custom formulation and color for the intended contact conditions.

Hardness selection

Silicone: 20–80 Shore A. At the same time, the panel openings must leave enough clearance for movement without exposing excessive gaps around the keys.

Custom dimensions

Users may hold the product in one hand and reach several controls with the thumb, so the spacing and height of molded silicone buttons should be considered alongside the width and shape of the housing.

Fit & assembly

Press from different angles and check whether the product shifts in the hand or an adjacent button moves unintentionally.

Use & inspection

When cleaning, concentrate on residue around the key boundaries without pushing liquid into the enclosure.

Photos illustrate structure or material only. Internal support and contact location should follow the chosen layout rather than being treated as an afterthought. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.