non-slip rubber feet for glass table wear resistant

Rubber feet for glass table assemblies provide a flexible contact layer at the intended support location. Their custom shape and size should match the table's actual arrangement, whether the rubber sits in a defined seat or beneath a supporting component. The glass contact area needs particular care during installation and routine cleaning.

A small hard particle trapped against glass can become a concentrated contact point. Clean the rubber face and the glass before assembly, then place the support without dragging it across the surface. The part should sit flat so that a folded edge does not carry the load alone.

Choose the profile around the table's support layout and finished height. All intended contacts should engage together, with sufficient retention to keep the feet from migrating during normal use. Rubber contact does not replace the structural requirements of the table. When moving or cleaning the assembly, inspect each support for displacement and embedded debris. Replace a damaged foot with the correct geometry so the glass remains supported as the design intends.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Assess the grade against this fit requirement: The part should sit flat so that a folded edge does not carry the load alone.

Custom profile & fit

Choose the profile around the table's support layout and finished height.

Assembly considerations

Rubber feet for glass table assemblies provide a flexible contact layer at the intended support location.

Design check

When moving or cleaning the assembly, inspect each support for displacement and embedded debris.

Photos illustrate structure or material only. The part should sit flat so that a folded edge does not carry the load alone. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.