OEM rubber furniture black crutch feet stool chair leg tip

A custom black stool chair leg tip provides a rubber contact at the end of a furniture leg. The socket, retained length and floor-facing base should suit that specific furniture configuration, with the leg fully seated before its contact is assessed.

ETOL offers molded dimensions, materials, hardness and colors. Compare the finished leg end, including any taper or angled cut, with the inside of the tip. Keep a furniture foot configuration distinct from a crutch-tip configuration; each needs evaluation within the complete product it supports.

Remove debris and inspect the leg end for sharp features before fitting. Seat the tip with the furniture supported, then lower it onto a clean, level surface to check that the base meets as intended. If the cover is partly inserted or tilted, correct that fit before use. Lift the furniture when relocating it, and inspect for grit or a rolling edge during routine care. Replace a worn-through or split tip rather than leaving the bare leg close to the supporting surface.

Material options

Rubber compound options, customized alongside the profile and contact conditions.

Hardness selection

Solid rubber options: 30–90 Shore A. If the cover is partly inserted or tilted, correct that fit before use.

Custom geometry

ETOL offers molded dimensions, materials, hardness and colors.

Fit evaluation

Compare the finished leg end, including any taper or angled cut, with the inside of the tip.

Color & OEM

Custom colors; OEM markings clear of the working interface.

Photos illustrate structure or material appearance only. The socket, retained length and floor-facing base should suit that specific furniture configuration, with the leg fully seated before its contact is assessed. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.