Anti slip protective push rubber feet tips for table leg

These rubber feet tips push over table-leg ends to provide a cushioned contact with the supporting surface. Their retained fit matters when the table is moved into position: a loose tip may stay on the floor as the leg is lifted, while an excessively tight one can be difficult to seat completely.

Dimensions, compound, hardness and color are customizable. Match the finished leg and check for obstructive paint buildup or welds. Push the tip on squarely while the table is supported, then inspect the bottom face before applying weight.

Use matching seating depths across the table so one leg does not stand taller simply because its foot is partly fitted. Keep the contact faces clean and inspect them if the table begins to slide or rock. The rubber interface should complement a stable table structure; it should not be used to conceal a bent leg or a loose frame connection.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Compare firmness under load at the intended contact face. Use matching seating depths across the table so one leg does not stand taller simply because its foot is partly fitted.

Custom profile & fit

Match the finished leg and check for obstructive paint buildup or welds.

Assembly considerations

Their retained fit matters when the table is moved into position: a loose tip may stay on the floor as the leg is lifted, while an excessively tight one can be difficult to seat completely.

Design check

Keep the contact faces clean and inspect them if the table begins to slide or rock.

Photos illustrate structure or material only. Table-leg tips need matching seating depths so partially fitted rubber does not leave one support taller than the others. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.