Custom made rubber tips and caps for chair leg

Rubber caps for chair legs cover the ends with a custom molded contact layer. The internal socket should follow the receiving leg, while the base meets the floor in the chair's normal stance. The insertion depth matters as much as the width of the leg at the opening.

Check whether the leg tapers or changes shape inside the cap. A tip can grip at its upper edge while stopping too early to support the base properly. The bottom profile also needs to suit any leg angle so the chair rests across the intended contact area.

Clean the leg end and remove sharp material before fitting. Seat the cap fully, then compare all feet on a level surface to check for rocking. Keep grit from collecting beneath the rubber during use. Inspect the tips after the chair has been moved, looking for splits, displacement, or wear near the hard leg end. Replace damaged parts with matching installed heights so the original stance is preserved.

Material options

Rubber compound options, customized alongside the profile and contact conditions.

Hardness selection

Solid rubber options: 30–90 Shore A. The insertion depth matters as much as the width of the leg at the opening.

Custom geometry

The bottom profile also needs to suit any leg angle so the chair rests across the intended contact area.

Fit evaluation

Seat the cap fully, then compare all feet on a level surface to check for rocking.

Color & OEM

Custom colors; OEM identification positioned outside closure contact surfaces.

Photos illustrate structure or material appearance only. The insertion depth matters as much as the width of the leg at the opening. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.