Small diameter rubber cone tips feet for metal chairs

Cone-shaped rubber feet for metal chair legs need receiving cavities that match the legs while the conical outside profiles suit the available space. The narrowest visible diameter does not necessarily describe the opening or base-contact area. Those features should be measured separately.

Check the metal end for burrs and local damage before fitting. A small tube edge can concentrate force inside the tip, especially if the leg does not reach its intended seat. The base should meet the floor in the chair's normal position without the conical sidewall folding underneath it.

Fit the selected tips consistently and assess the chair as a set. The shape alone does not establish a supported load or a particular floor-grip value. During care, clean the contact surfaces and inspect the transition between the opening and wider body for tears. Replace a tip that creeps off the leg rather than relying on the cone shape to retain an opening that does not match the receiving tube.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Assess the grade against this fit requirement: The base should meet the floor in the chair's normal position without the conical sidewall folding underneath it.

Custom profile & fit

The narrowest visible diameter does not necessarily describe the opening or base-contact area.

Assembly considerations

Check the metal end for burrs and local damage before fitting.

Design check

Fit the selected tips consistently and assess the chair as a set.

Photos illustrate structure or material only. The shape alone does not establish a supported load or a particular floor-grip value. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.