Rubber chair feet,rubber chair leg tips,rubber cane tips

Rubber chair feet provide covered contact points beneath furniture, helping keep exposed leg ends from meeting the floor directly. The receiving profile should match the chair's actual leg, including its end angle and any taper. The internal seat determines the final support height, not just the cover's outside dimensions.

For chair use, check the installed feet as a set so the furniture rests without an uneven corner. Remove dirt and sharp damage from the leg ends before fitting. During cleaning, inspect the underside for embedded grit and thinning rubber where the hard leg presses against the base.

A cane tip is a separate application with its own compatibility and support requirements. A furniture foot should not be assumed suitable for a mobility aid merely because it fits over the same nominal tube diameter. Keep replacement parts matched to their intended use, and replace worn or loose fittings before the receiving end becomes exposed or the original contact geometry is lost.

Material options

Rubber compound options, customized alongside the profile and contact conditions.

Hardness selection

Solid rubber options: 30–90 Shore A. The internal seat determines the final support height, not just the cover's outside dimensions.

Custom geometry

The receiving profile should match the chair's actual leg, including its end angle and any taper.

Fit evaluation

For chair use, check the installed feet as a set so the furniture rests without an uneven corner.

Color & OEM

Custom colors; OEM markings clear of the working interface.

Photos illustrate structure or material appearance only. The internal seat determines the final support height, not just the cover's outside dimensions. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.