50mm rubber tip/ Rubber sleeve cover for table legs

The 50mm rubber tip is a customizable cover for a table-leg end. The size in the name is a starting reference; the internal socket, outer footprint and depth must be matched to the particular leg before fit can be established.

Measure the bare leg near its end and identify any taper. A cover that fits the first few millimeters may stop short farther along, leaving an unsupported space at the bottom. Conversely, extra socket clearance can let the tip twist when the table is repositioned. Material, color and hardness options allow the cover to be developed around the furniture design.

Remove sharp edges and trapped debris before pushing it on. With the table supported, seat the cover evenly rather than hammering the base against the floor. Lower the table and check for a folded rim or uneven contact. Inspect the inside whenever the tip is removed; debris caught there can work between the leg and rubber during movement and gradually affect the fit.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Assess the grade against this fit requirement: Lower the table and check for a folded rim or uneven contact.

Custom profile & fit

Measure the bare leg near its end and identify any taper.

Assembly considerations

Inspect the inside whenever the tip is removed; debris caught there can work between the leg and rubber during movement and gradually affect the fit.

Design check

A cover that fits the first few millimeters may stop short farther along, leaving an unsupported space at the bottom.

Photos illustrate structure or material only. Conversely, extra socket clearance can let the tip twist when the table is repositioned. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.