Non-slip Rubber Pad for Chair Leg and Furniture

A Rubber Pad for Chair Leg contact should follow the area that actually meets the floor when the chair stands normally. An angled leg may use only part of its apparent underside, so pad placement needs more than a comparison with the outer leg outline.

ETOL can customize dimensions, material, hardness, color and structure. Identify the available attachment surface and the intended floor contact. Keep the rubber from overhanging an edge that will catch during routine chair movement.

Fit the pad on a clean, stable area using the chosen attachment arrangement, then inspect it with the chair on a suitable level surface. Check that the pad lies flat and does not introduce an uneven stance. Evaluate movement against the actual floor finish and keep grit off the contact face. Lift the chair when repositioning it to avoid dragging a pad edge loose. If wear is concentrated on one side, review the leg angle and pad location before replacement rather than covering the same misaligned contact with another piece.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Assess the grade against this fit requirement: Keep the rubber from overhanging an edge that will catch during routine chair movement.

Custom profile & fit

An angled leg may use only part of its apparent underside, so pad placement needs more than a comparison with the outer leg outline.

Assembly considerations

Fit the pad on a clean, stable area using the chosen attachment arrangement, then inspect it with the chair on a suitable level surface.

Design check

Check that the pad lies flat and does not introduce an uneven stance.

Photos illustrate structure or material only. A Rubber Pad for Chair Leg contact should follow the area that actually meets the floor when the chair stands normally. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.