Good quality customized small rubber bushing rubber sleeve

A custom rubber bushing rubber sleeve has a wall section defined by its inner and outer dimensions. That section should suit the support and movement required in the assembly. Material, hardness, size, and color can be adapted once the two mating interfaces are established.

Compare the outside seat and the center component independently. Enlarging the passage or changing the outer diameter also changes the amount of rubber between them. The sleeve length and any end features must then fit the available axial space.

Guide the sleeve into position without cutting its edge or rolling an end inward. Check the fit again when the center component is inserted, since that action can displace the body. Select the compound for the actual temperature and substances at the interface. During maintenance, inspect the inner surface for rubbing and the outer region for movement in its seat. Preserve the specified wall geometry when replacing the part rather than choosing only by the dimension easiest to measure.

Material options

Rubber. Custom formulation and color for the intended contact conditions.

Hardness selection

Rubber: 30–90 Shore A. That section should suit the support and movement required in the assembly.

Custom dimensions

A custom rubber bushing rubber sleeve has a wall section defined by its inner and outer dimensions.

Fit & assembly

Check the fit again when the center component is inserted, since that action can displace the body.

Use & inspection

During maintenance, inspect the inner surface for rubbing and the outer region for movement in its seat.

Photos illustrate structure or material only. The sleeve length and any end features must then fit the available axial space. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.