Molded high quality rubber feet/bumper for chair protection

A molded bumper for chair protection introduces a defined thickness of rubber at a contact point. That thickness affects the space between the chair and the surface it meets, so a replacement should reproduce the intended installed relationship. A much thicker bumper can redirect contact or prevent parts from reaching their normal position.

Check the receiving area for an original recess, hole or locating feature. These details indicate how the part should be retained and which face should receive contact. The rubber must be supported behind its working surface instead of hanging over a sharp edge that can cut it when compressed.

After fitting, assess the chair in the position where the bumper is used. Confirm that contact lands on the rubber and that nearby surfaces remain clear as intended. During maintenance, inspect for loosened retention and a contact face that has worn at an angle. Repeatedly replacing an unevenly worn bumper without checking alignment can leave the same hard edges meeting again after a short period of use.

Material options

Rubber compound options, customized alongside the profile and contact conditions.

Hardness selection

Solid rubber options: 30–90 Shore A. The rubber must be supported behind its working surface instead of hanging over a sharp edge that can cut it when compressed.

Custom geometry

Check the receiving area for an original recess, hole or locating feature.

Fit evaluation

Confirm that contact lands on the rubber and that nearby surfaces remain clear as intended.

Color & OEM

Custom colors; part identification clear of mounting seats and loaded faces.

Photos illustrate structure or material appearance only. The rubber must be supported behind its working surface instead of hanging over a sharp edge that can cut it when compressed. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.