Custom made wholesale silicone push in rubber feet

Custom silicone push in rubber feet use a molded retaining feature to locate the foot in an opening. The retaining shape should match the hole and panel thickness, while the exposed pad provides the intended stand-off. A correct installed height depends on the foot reaching its full seat.

Prepare the opening by removing sharp burrs and debris. Fit the retaining section through the intended installation method without cutting a thin rubber edge. Inspect around the base and, where possible, behind the panel to confirm engagement. A partly inserted foot may look secure from above but leave the equipment standing unevenly.

The complete support set should be checked with the product in its normal configuration. Material and dimensions need to suit the contact surface and loading. During maintenance, inspect the hidden retaining section if a foot repeatedly loosens. A replacement must match the full geometry rather than only the visible pad, since a different stem can change both retention and installed projection.

Material options

Custom silicone or rubber formulation, with dimensions and color adapted to the mating component.

Hardness range

Silicone: 20–80 Shore A; rubber: 30–90 Shore A. Assess the grade against this fit requirement: Material and dimensions need to suit the contact surface and loading.

Custom profile & fit

The retaining shape should match the hole and panel thickness, while the exposed pad provides the intended stand-off.

Assembly considerations

Fit the retaining section through the intended installation method without cutting a thin rubber edge.

Design check

Inspect around the base and, where possible, behind the panel to confirm engagement.

Photos illustrate structure or material only. The retaining shape should match the hole and panel thickness, while the exposed pad provides the intended stand-off. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.