Rubber foot sleeve protective chair leg silicone feet

Chair leg silicone feet should fit the leg profile over a defined engagement length. The sleeve cavity needs to follow the finished leg, including coatings, taper and corner shape. A close fit at the opening may still leave the leg unsupported deeper inside the foot.

Custom dimensions, material, hardness and color can match the chair design. Check how the leg meets the floor and whether the sole rests evenly in the normal loaded position. The complete set should preserve the chair's intended stance.

Inspect the leg ends for sharp edges before fitting and clear particles from the cavities. Seat each sleeve without folding its opening inward. Evaluate movement and surface marking on the actual floor finish where appropriate. During maintenance, remove grit from the soles and compare wear across the chair. If one sleeve repeatedly loosens or wears through, review the leg geometry and loading at that position. A thicker silicone foot will not necessarily correct a rail end that is sharp or poorly seated.

Material options

Custom silicone or rubber formulation, with dimensions and color adapted to the mating component.

Hardness range

Silicone: 20–80 Shore A; rubber: 30–90 Shore A. Assess the grade against this fit requirement: Check how the leg meets the floor and whether the sole rests evenly in the normal loaded position.

Custom profile & fit

The sleeve cavity needs to follow the finished leg, including coatings, taper and corner shape.

Assembly considerations

Inspect the leg ends for sharp edges before fitting and clear particles from the cavities.

Design check

Evaluate movement and surface marking on the actual floor finish where appropriate.

Photos illustrate structure or material only. The sleeve cavity needs to follow the finished leg, including coatings, taper and corner shape. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.