Custom made air vacuum glass silicone sucker

A glass silicone sucker should be placed where its whole rim can contact a suitable continuous surface. A nearby edge, seam, or raised decoration can interrupt that path even when the center of the cup sits flat. Select the profile and mounting position around the actual glass feature rather than the general panel size.

Check the load direction and any leverage introduced by the attached component. Include the intended movement and vacuum operating arrangement where applicable. The complete setup needs assessment under those conditions before a working holding requirement is assigned to it.

Clean the rim and glass by a method suited to both materials. Inspect the lip for cuts and verify the mounting hardware does not tilt the cup. Release before repositioning instead of dragging the attached cup across the surface. During maintenance, compare repeated wear with the contact location and motion path. Correct those conditions before replacement rather than assuming a larger footprint will avoid the same interruption at the glass surface.

Material options

Custom silicone compound; formulation and geometry developed together.

Hardness selection

Silicone options: 20–80 Shore A. Check the load direction and any leverage introduced by the attached component.

Custom geometry

Select the profile and mounting position around the actual glass feature rather than the general panel size.

Fit evaluation

Release before repositioning instead of dragging the attached cup across the surface.

Color & OEM

Custom colors; OEM markings outside the suction contact face.

Photos illustrate structure or material appearance only. A glass silicone sucker should be placed where its whole rim can contact a suitable continuous surface. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.