Factory custom made molded rubber tip foot chair

A molded rubber tip can restore a covered contact point to a chair leg when the original foot has worn away or gone missing. The replacement needs to match both the leg end and the remaining feet. Its external height alone does not show the final chair height because the leg may sit at a different depth inside the new part.

Inspect the leg that lost its tip for the cause. A sharp edge, distorted tube or recurring sideways drag can damage a new fitting in the same place. Correcting the receiving surface is part of achieving a useful replacement fit, rather than simply pressing on a thicker cap.

Compare the chair's contact points once the new tip is seated. If one corner sits high, review the internal seating depth and the condition of the other feet. Keep the floor-facing rubber clean and check the replacement after normal use. Early movement, a rolled rim or a new split indicates that the profile or retention needs further attention.

Material options

Custom rubber compound and color, selected for the contact conditions and required geometry.

Hardness range

30–90 Shore A for rubber. Assess the grade against this fit requirement: A sharp edge, distorted tube or recurring sideways drag can damage a new fitting in the same place.

Custom profile & fit

If one corner sits high, review the internal seating depth and the condition of the other feet.

Assembly considerations

Compare the chair's contact points once the new tip is seated.

Design check

Keep the floor-facing rubber clean and check the replacement after normal use.

Photos illustrate structure or material only. Early movement, a rolled rim or a new split indicates that the profile or retention needs further attention. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.