Sticky silicone rubber pad anti slip rubber bumper

A sticky silicone rubber pad can provide a tacky contact interface beneath a suitably matched object. The nature of that contact should be established for the selected pad; a tacky surface is not automatically the same as a permanent adhesive backing. The receiving finish and the forces applied during use affect how the pad behaves.

Choose a clean contact area with enough support for the pad's full outline. Texture, dust and oily residue can interrupt contact, while a pulling force at one edge can lift a pad that appears secure under downward pressure. Any intended load or retention duty needs evaluation in that arrangement.

Check compatibility with the actual finish before extended placement, including whether removal leaves residue or marks. Use the intended cleaning and reuse method rather than assuming washing will restore every formulation. Inspect the pad for trapped particles and torn edges. If used as a small bumper, position its contact face where the opposing part meets it without repeatedly peeling the pad away from its mounting surface.

Material options

Custom silicone or rubber formulation, with dimensions and color adapted to the mating component.

Hardness range

Silicone: 20–80 Shore A; rubber: 30–90 Shore A. Assess the grade against this fit requirement: Any intended load or retention duty needs evaluation in that arrangement.

Custom profile & fit

Check compatibility with the actual finish before extended placement, including whether removal leaves residue or marks.

Assembly considerations

If used as a small bumper, position its contact face where the opposing part meets it without repeatedly peeling the pad away from its mounting surface.

Design check

The nature of that contact should be established for the selected pad; a tacky surface is not automatically the same as a permanent adhesive backing.

Photos illustrate structure or material only. If used as a small bumper, position its contact face where the opposing part meets it without repeatedly peeling the pad away from its mounting surface. ETOL directly manufactures custom-shaped silicone and rubber parts to your requirements.